4 hours ago Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

will not start?

chainsaw ran out of fuel after refueling will not start
is it possible to check ignition timing
model MS180
bill, March 2009
Reckon you need to pull through the fuel after running it dry, try dripping fuel down the carb and pulling the engine over, the engine should fire for a short while and the compression should pull some fuel through.

steve, March 2009