Hi My Peugeot 307sw 52 reg brake lights have failed. The bulbs and fuses are ok. Also, the car lights turn them selves on whilst I am driving. Peugeot want £75 per hour plus VAT to diagnose.
Any ideas? Does anyone have a wiring diagram?
Thanks
Thanks to reading these answers.. I did the switch replacement myself... .. Rather chuffed
Tanya, August 2017
you must twist anti clock to remove and clockwise to fit get someone to push brake pedal befor fitting hold down and fit then release after fitting, this also affects cruise control
tony, April 2016
the brake light switch is uder oass glive box its white and in a round plate right under
chris, November 2014
Hi I can't see any switch on my 307 Hdi 2002 ' I've pulled the carpet back under the glove box and the only thing I can see is a green plug with 2 wires that something goes into
joe, December 2013
307 on 2003 plate,similar problem centre brake light is working, brake lights are not, changed bulbs, all fuses look intact, the only thing out of the norm was reversing bulb had blown completely,
noel, June 2013
hi i'v got a peugeot 307 on a 55 plate brake lights ant working checked the fuses they are ok any surgestion plz
michelle, October 2012
Emergency braked and also lost my braking lights.!
Bashir, February 2012
Ive checkes bulbs and fuses on 51plate 307 1.4, pushed in etc, stil not working normal tail lights are working. So relay swich requires changing?
tony, January 2012
its usually the plunger that is pushed in to far on the brake switch you can pull it out as there are notches on it pull it out one inch then refit it is normaly caused by really heavy breaking that causes the plunger to go into the body of the switch , somtimes the plunger is broke or the switch has gone on the inside so you have to change it ,i got one on ebay for £18 here`s the link copy and paste it in your address bar http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=180594143032&ssPageName=STRK:MEWNX:IT -also note what type it is some are green ends and some are white replace like with like
wayne, May 2011
my brake light are stuck on and i was wondering if any one
knew how to test the switch or get them to go out.
thanks.
darren, January 2011
Don't forget when you do refit the break switch get someone to push on the break pedal then fit the switch and get the other person to release the pedal. This should reset it properly.
David, January 2011
i too have the same problem and have disconected and reconected the plug but still no lights, there seems to be a plug that isnt plugged into anywhere (just taped to another wire), if i were to buy a switch is it easy to fit or do you need to cut wires and things, thanks, Liam..
liam, December 2010
Just recently purchased a brake light switch and harness for our 55plate 307. Peugeot stated it is a common problem with these models of 55 and onwards. Total cost for parts £30, a 2 minuite fix, located under passenger footwell.
Paul Wrigley, November 2010
thanks for this, this was the problem on my one
PB, May 2010
same problem, you just saved me a fortune, thanks :)
Nige, May 2010
I had this problem and the brake light switch was out which i plugged back in. On the Peugeot 307 it is on the passanger side underneath the glove box.
Tarina, April 2010
rear break light on nsr not working brake light is working how can i fix problem
pete, March 2010
try taking trim off bottom of glovebox 3 cllips i think, then look up behind glovebox with torch. there will be brake light switch 2 wires coming from it. try pushing it in. if still not working probably switch gone. replace brake light switch. also which lights come on when driving??
