I am after a wiring diagram for the ZDC5350W Condenser Dryer. It's not drying properly and I suspect either the heating element or the thermal cut out has tripped. Not too sure where they are in the dryer, so a diagram would be great. Thanks for any help.

HSingh, March 2009

Thanks for the Info CK, I'll give it a go. Cheers.

H Singh, March 2009

remove back panel and lid to gain access to the heater.two stats on back of the heater should be normally closed circuit.one thermostat inside drum at front about 12 o clock.use a mirror held inside drum to see where I mean.again normally closed circuit.any of the above found open circuit will be the possible cause of your fault.

ck, March 2009