4 hours ago Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

homelite vac attack 2 30cc only runs at half speed ?

I have a 30cc homelite vac attack 2 gas blower. It cranks and idles fine but will only rev up to about half speed. I noticed that the spark plug wire has a small cut in it. I put electrical tape over it but it did'nt help. could that be the problem?
Larry T, March 2009
Possibly - make sure the cut is away or shrouded from the chainsaw metal case - take some similar diameter pipe, cut down the side and tape this round the fault. The problem is most likely to be a dirty air filter - most are washable in water or the "H" carb setting being too fully out, try one turn out once the filter is clean and dry.
If this fails, it may be a blocked main-jet

steve, March 2009
link Click here to see other fixes for Homelite.