When I turn on the power the display will just blink zero?
Plenty of paper, Printer seems to be working fine. When I power it up with key past the Z position, I get a beep and the following line prints on the Rcpt and Jrnl. STATU-S POO

Len, April 2009

Hi.
Blinking on a TEC means paper low or empty.
If you look under the paper rolls, you should see a lever under each one that gets pushed down when a roll is on top of it. Press them both down (jnl and rcpt sides) and the blinking should stop. If it doesn't, you probably have a paper detect fault.

Mark, April 2009