i have a gold's gym 450 treadmill with a mc-2100 motor controller and i'm getting power to everything but to the dc motor. lcd light is fully lit on control board. any suggestion's?

tattooyoung, April 2009

You should have a red led light up when you plug the treadmill into the outlet. When you send it a speed signal from the console, that red led should start blinking.

If it blinks, but the belt doesn't move replace the controller.

If it doesn't blink, check your upright wire harness. It will either be the wire harness or the console.

Good Luck

nordicgirl, June 2009