The washing machine is not long past it's guarantee, and the fault started last week.
First symptoms were that it stopped after the wash cycle, drained, but didn't step on to the conditioner cycle. It then switched to pause with the rinse light flashing. Have cleaned both inlet and waste filters. The machine is filling correctly and draining when required.
This morning the fault changed to a spin fault, so ran the 19 minute spin program. The drum starts to turn then the display switches to 1 minute and stops???
Am I looking at a blockage somewhere? The impellor on the drain pump turns with a long screwdriver but feels slightly coggy against the magnets (could be normal).
Could fault be a main PCB fault?
Look forward to your replies/help.

Flobber, April 2009

hi my beko machine has just gone past the warranty everything comes on it fills up with water but goes straight to spin but doesnt spin

yvonne, June 2010

Hi, Could you let me know what pcb it was that you replaced, because my machine has the same fault.

Thanks
Jonny

Jonny, November 2009

Curious to know which PCB you changed - was it the drive PCB of the main PCB at the front of the machine?
I have a machine that during the spin cycle, the drum motor starts but then stops after about 2 seconds.

John b, October 2009

Finally after 8 weeks of poor washing (no rinse and spin) and continuous nagging from the missus, my spare pcb arrived. I had tried all the other options, finally tracing a board via a well known trading site.

Fitting this pcb finally cured the above fault.

Flobber, July 2009