Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

how can i fix my zannussi washer dryer, wjs 1265 w?

In drying mode it 1st beqan beeping and E10 error code flashed. i cleaned fluff filter and after a few mins same again! I noticed the clothes were cold, but tumble worked. I emptied machine and started a boil wash, to clean it out. This began to indicate longer time left than it began with, so i skipped thru program and as it was draining it tripped out elec ring and now as soon as i turn it on it trips, so i cannot open door!
mia newbury, January 2006
If E10 is only appearing when trying to dry, the problem almost certainly is the condenser valve solenoid open circuit. The green solenoid on the inlet valve. Should read about 4000 ohms.
I CHECKED AND CHANGED THE TRIPLE INLET VALVE ON MY MACHINE, NOW ALL OK. PART NUMBER 1249472117 FROM SERVICE FORCE AT HAYWARDS HEATH(01444417655) PRICE £19.59, COLLECTED

RICHARD STEERS, January 2006