home Fix label Vehicles label_important Motorcycles

CBR 125 (SONIC ASIA) Exhust vale keeps on going tight?

the exhaust tappet clearance keeps closing thus stopping the engine on tick over, this is after replacing the tappet screw and nut, would this be a problem with the cam?? Thank you if you can help. J. Corkin Thailand

John Corkin, April 2009

home Fix label Vehicles label_important Motorcyclesdone

Ok John Thanks for your help I think you are right about valve seat will check if necessary. John Corkin

John Corkin, May 2009

If the cam was wearing, the tappet clearance would actually increase, rather than decrease....the normal situation here would be the valve wearing into its seat, due to the hard coating being worn away. I can't think of any other reason for this one!

John, April 2009

link Click here to see other fixes for 125.

Fix Fault - Vehicles

home label Vehicles label_important Motorcycles

home Fix label Vehicles label_important Motorcycles

CBR 125 (SONIC ASIA) Exhust vale keeps on going tight?

I can answer this question...

CBR 125 (SONIC ASIA) Exhust vale keeps on going tight?

I can answer this question ...

CBR 125 (SONIC ASIA) Exhust vale keeps on going tight?

Direct bike?

How to change oil pump on apache 100cc quad?

My DB50QT-11 won't accelerate and cuts out after 20 seconds of running?

Yamaha vity 125?

Yamaha jog rr ignition ?

aprilia sr50 motard front lights?

Read below ?

non start fuel issue ?