Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    Click here to ask your question

how to test ignition coil on 036?

why want my stihl 036 saw want fire.what is the gap settings between moduel flywheel
oli, May 2009
i have a 036 it ran 2 hr later it does not run it will not fire off it is geting spark and fule

lonnie, June 2012
Usually a double thickness of typical printer paper does it - you can check the spark by taking the plug out, putting it in the cap, earthing it on the cylinder head and give the starter a hard tug, you should see a spark around the electrode - if you dont then the plug, the stop switch or coil are probably shot.

Steve, May 2009