We started receiving an F1 error code at about 3 AM one morning when the dishwaser was not even in use. I removed both tubs and turned them on their sides to see if there was excess water in them. There was only a little residual in each of them. After plugging the machine back in and turning on the water, I was able to run through a 10 minute rinse cycle with no problem, however, a few minutes after the rinse cycle had completed I started receiving the F1 error message again.
Any ideas?

Mike Welsh, January 2006

the best thing you can do is junk it and buy a goo one. i had one for 5 years and had almost as much in repair bills as i paid for it. they are junk

butch, June 2006