Hi Eileen: firstly remove the lid held on by three screws at the rear, open the door and remove the large clip holding the seal on the out side and pull the seal off on the outside next at thebottom of the machine where the front goes in you will see three screws holding the front of the machine on remove these, next remove the dispenser drawer and remove the four screws holding the facia on pull the timer knob and remove the facia. you will now see three screws holding the front of the machine remove these and you should now be able to swing the front to the right hand side to enable you to get to the tub (if you wish you can remove the door interlock by removeing the two screws holding it to the front and then you can remove the front entirely) remove the clip holding the door gasket to the tub then pull the old gasket off taking note of how it was fitted install the new gasket and replace the clip then reassemble the front and facia. at this point if you removed the door interlock replace it before fitting the gasket to the front replace the clip and off you go
RS, September 2004
