My washing machine displayed the error code 66, does anyone know what that means and how to fix it is? Thank you.

Lenihan, June 2009

Error code for frequency out of range for water level transducer.
Usually caused by small surface mount electrolytic 10uF cap with out of spec ESR (>5ohms). Cap located in close proximity to transducer element in phase 6 driver board.

James Whistlebritches, December 2016

how much to repair code 66 ?on my fisher & paykel washing machine?

sandy, November 2014

How did you read the error code 66? This is an unusual fault that does not come up too often. Error 66 is a pressure sensor fault. Service manual says:
The Motor Control module has received signals from the water level sensor (Ptx)
above normal frequency values.
Primary Source: Motor Control module
Action: Replace Motor Control module
So if fault is persistent and keeps coming up then you will need to have the controller replaced.

Lincoln Appliance NZ, June 2009