Hi,
I have the User's Guide and all the instruction I need on how to thread the bobbin. However I spent endless hours trying to get the thread out of the center where normal it is hooked on after lowerng and then raisin the needle. Looking at the bobbing, I just can't see how it will hook onto the upper thread through the needle when the bobbin it does not move neither its thread. The only thing that rotates around is the casing / the housing that the bobbin is dropped in to it. I am missing something - please help. I have been doing exacly what the instruction indicates but absolutely no luck.

Lou, June 2009

I was wondering if there is fine adjustment within the bobbin case area in order to position the hook back to its correct position (just pass and above the needle hole) as the needle begins to move upward.
Thanks

Lou, June 2009

THANKS KEN!
IT WORKED!

Lou, June 2009

Thank you Ken.

I received your instruction. I will try it today and will keep you posted.

Thanks again!

Lou, June 2009

Hello Lou,
Keep reseting the timing as the instructions that is the problem, it may take several attempts.
Ken

drivewithken, June 2009