2 hours ago Jo asked ... How to engage clutch on old sewing machine to engage needle?    |    Jacky asked ... Miele Vacuum cleaner?    |    Ben asked ... Toyota Yaris French or Japanese?    |    Andy asked ... How can I mend my MacAlistair 450w hedge trimmer?    |    Felix asked ... Hitachi vt-m70em?    |    Click here to ask your question

Holes where screws go are worn?

How do i put a screw in hole that has gone too big
Gill, July 2009
Put a drop of glue into the hole and break off some toothpicks into the hole to fill it.Cut off the exess with wire cutters and tap the rest down with a small hammer until it is flat to the surface.Re-open the hole with an awl or small nail,enough to re-start your screw.

raymonster, August 2009
thank you

gill, July 2009
Three solutions...

Bigger screw (not always possible)

Drill wood and glue in dowel (have to wait for glue to set & drill pilot hole)

Put small pieces of wood in hole - matchstick - cocktail stick pieces (quick, easy and cheap)

Good luck...

Peccavi, July 2009