a a5 pouch has become stuck inside the laminator and am unable to get it out as not visible. only 2 screws underneath which dont seem to undo anything. any ideas to be able to undo cover if possible to get at the fried pouch would be appreciated, as makes a crunching noise when turned on and unable to use, pouch must be stuck some where inside.
Thanks so much to everyone here! The receptionist was about to kill me....
Joe, January 2016
thanks, this saved me! and my laminator :)
Monica, August 2015
Excellent, worked like a charm (see answers below):
----------------------------
There are 4 additional screws under the rubber footings. Pop them off with a knife and then undo the screws.
Stu
April 2010
------------------
You should be able to undo the screws and pop off the white section of the laminator away from the grey plastic.
bec
August 2009
JamesOb, June 2015
great tip thanx worked like a charm...just remember if it got stuck a few minutes back....yes it is still warm...lol!
jo, September 2014
Just fixed my MARS 125 tonight using the instructions in this thread! Thank you all! :D
EB, April 2014
Thanx for the tips! I made my laminator!
Gekkegettie, May 2013
How do you get the cog off? I can't undo the screw!
Frustrated but determined!, February 2013
Stu is 100% correct...thanks man! I was just able to pull out a stuck sheet because I could get off the cover... careful when you pull off the cover that the internal 4 springs do not fall away from their intended position.
Kevin, September 2011
Than you unscrew the motor off the end the unscrew the cog pull the other ine off, the n you should be able to put to get the pouch back out and put it all back together!
Max Hardy, March 2011
There are 4 additional screws under the rubber footings. Pop them off with a knife and then undo the screws.
Stu, April 2010
Your should be able to undo the screws and pop off the white section of the lamiator away from the grey plastic. The plastic is tough though and could break if the plastic tabs don't pop out.
