Accenta house alarm system installed 2 years ago, installer no longer in the business. Is the engineers code set by the manufacterer when built? I have a faulty P.I.R. which I wish to change. Is the procedure enter own code, then engineers code, do the job, then reset and test?

herbert, August 2009

reset the panel to factory set Standard method to reset to full factory set conditions Power down the panel, remove any connections in "Set Output" terminal and PA Imnput terminal fit a shorting link between these terminals power up, wait for alarm to start, power down remove shorting link and refirt original wiring, power back up code will now 1234
then you can set your own codes, see honeywell site as they have a lot of the manuals available if you have lost yours

dave c, August 2009

call me i will advise

gerry 07817389252

gerry, August 2009