I am looking to replace the fuse inside the tumble trier, the last time I had a guy out he left me fuses, but I cannot locate where it is, can you help

Michelle Campbell, August 2009

Hello I have had a repair man out to look at my dryer which just stopped. He has ordered 3 parts one of which he cant get a cable harness WPLC0034388. Would you know where to get one please. Repaircare are telling me nothing they can do, and the dryer will have to be dumped. Its a dryer over £400 seems a shame.

Margaret B., December 2019

Agreed, took 3 screws out at rear top of machine to remove top panel. took 3 screws out at left hand long panel shaped 3 inches wide by about 60cm long, tilted up and found yellow wire became red wire and fed into black fuse holder, need to make sure its a "slow blow" 6,3 amp fuse.
all well after that. if not their is a circuit diagram on back of lower front panel.

alan renwick, October 2009

OOoops. Take the lid off after isolation. LOL.

joe, August 2009

top left hand side under black metal panel, held on with 3 screws. 6.3a fuse required.

Caution. HIGH amperage device. MAKE SURE YOU ISOLATE IT !!

joe, August 2009