Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Veritas 8 tamper problem?

my alarm goes off intermittantly, always showing zone 2 tamper. I placed a link in the main panel to remove the tamper system altogether, but the problem still occurs. New panel?
Dumbfounded, September 2009
Sorry for the delay, i have linked out zone 2 in the main panel. It seemed ok for a few days then just the tamper goes off without showing a zone light. Regards

D'founded, September 2009
if the alarm tampers and it shows tamper and zone 2 together then theres a problem with zone 2 it could be faulty if you open zone 2 pir check the wires it should have a tamper terminal and if wires go in to the terminal check there not loose and most of all check the 12v and ov it should be they might be red and black or black and red check there not loose then reconect the pir and open the main panel and check zone 2 in the panel no wires are loose and then look for aux in the panel and check no wires are coming out of the aux thats red and black in the panel aswell get back to me if that works

death, September 2009
Hi Death,
yes the sensor lights up. I did wander about the sensor but couldn't see why it would bring on the tamper.

dumbfounded, September 2009
nope not a new panel when you move near zone 2 does the sensor light up

death, September 2009
link Click here to see other fixes for Veritas 8.