Morne asked ... My defy dtl 125 toploader?    |    Ernie asked ... How to fix gearchange ldv maxus van 2006?    |    Cuckoo asked ... Changing batteries on a fixed bt corded phone?    |    Marc Nollid asked ... Nissan Micra mk 5 2018 rear seat mecanism?    |    Maggie asked ... New Home 535?    |    Click here to ask your question

How do I repair a plastic stihl tank?

After driving the trailer over my Stihl chain saw I have a small leak in the plastic petrol tank. While I can buy a new tank it does form the base/frame of the saw which means a big strip down and rebuild.

I was wondering if there is a kit or product to repair the leak which would stand up to petrol and also stick to the plastic, the plastic has a reference number which is PA 66\GF.

This reference is the same as the chain guard and I am wondering about melting some of this into the crack if there is no other suitable product.

Any suggestions?
Mike, September 2009
Thanks Ken.
Before I read your suggestion I had already tried a hot soldering iron on the chain guard. My iron wasn't hot enough but I see it has possibilities but may need extra plastic for filling/mending.

Since then I have bought some Araldite extra strength SuperGlue which comes in two test tubes. Mix the two together for 15 seconds and apply immediately. I have now used the saw for an afternoon and it seems to be holding so keeping fingers crossed. Cost of repair less than £4.

Mike, October 2009
try cleaning out tank and repair with a hot soldering iron
be careful not to melt to much plastic

ken day, October 2009
link Click here to see other fixes for Stihl.