andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

HJA 8630 over fill?

DW works half way thru programm then stops. Fills no motor action then fills again and again till over fill. Any ideas????
R.CaRPENTER, October 2009
Are the filter groups blocked? They are in the base under the lower spray arm. There are three filters; Main filter, Coarse filter and Micro filter. First remove the Coarse and Micro filter assembly by turning the Coarse filter anticlockwise and lift up. Then press the two tongues inwards and pull out the Coarse filter from the Micro filter. Next remove the Main filter mat by lifting up from the front. Clean all filters with a brush under a running tap. Note that when putting the Coarse filter back into the Micro filter the marks must align. Refit the Main filter mat then refit the Coarse/Micro filter assembly by turning clockwise until you hear a click.

Ced., December 2009