Hi
Our washing mach makes a very loud banging when spinning at high speed but not when slow, do you think this is the bearings, dampers or just a slipping belt, I have tne back off and there is a lot of black round the motor area although the belt is still intact?

Darren Adams, October 2009

No noise from the drum if you spin it by hand, i can see the bearing at the back with the cover off and it does not look worn or broken up, is this the bearing you are referring too its in the middle of the drum drive wheel

Darren Adams, October 2009

does the drum rumble if you spin it by hand?.can you lift the inner drum up and down?.if so suspect bearings.major strip down to repair.callout repair cost £140ish (done properly)

tim, October 2009