for big but shallow bumps, use a sink plunger - it will suck the panel back out. for big, tight dents, drill a small (3/4mm) hole in the centre of the worst bit (works great if your ding is over a bit of trim - hides the hole). use a bit of stiff rod (piano wire works great - get it in model shops) make a right angle near the end. hook the rod through the ding and give it a good yank. fill the hole you drilled!. for small dings, use filler and sand smooth with wet and dry paper. finish it with primer and then paint it
JamJam, December 2004
