Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Candy ECO 1001 does not heat water ?

Hi,

My Candy ECO 1001 doesn't seem to be heating up its water anymore. It works ok, just everything comes out stone cold.

Is there a heater element I can fix? I read something somewhere else about checking for continuity - does this mean checking terminals are connected.... and would this require soldering ?

Many thanks!! :)
Ron Coobie, October 2009
No, you misunderstand. "Checking continuity" means checking there is no broken wire, or "open circuit" to put it another way. Buy yourself a cheap multimeter, read the instructions, then check the resistance of the heater at the terminals. On 1 x ohm scale it should read around 25 to 28 ohms. Make sure you unplug the washer first!

Mike, October 2009
link Click here to see other fixes for Candy.