Our Hoover washer dryer is about 8 yrs old and has started an intermitant problem of not pumping out the rinse water. It does pump out the soapy water in the earlier part of the cycle.
As the problem is always in the rinse part of the cycle, I'm thinking it may be a programmer contact problem.
Any thoughts ? Do you have a circuit diagram in .PDF format that I could have ?
I have multimeter and am ok to make electrical tests as required.
thanks Keith

Keith V, October 2009

I think you are barking up the wrong tree.
I think your pump is shot or partially blocked...but who am I to argue.
It is not possible to post files on this forum & rightly so. If you want a schematic that bad you would have to risk posting an e-mail address. Personally speaking I wouldn't even consider doing it...being bombarded by spammers or other cranks certainly does not appeal to me.

Mike, October 2009