Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

no power to dryer?

I get power to everything on the dryer but the heating element to a Kenmore dryer. The model no.#86581810, serial no.#M61166477
James Jackson, March 2006
Check your power source for 240vac between L1 and L2, if good then unplug unit and check for continuity at your heating element and on all three thermostats and thermal fuse, if that checks out ok use your wiring diagram located inside of your control panel to check for continuity between the centrifigual switch on the motor (engages neutral side of heater element). To keep it simple just remove the back panel (use gloves the sheet metal is sharp) and check input volt and your fuse and thermostats (these are the more likely causes of your problem). good luck

Kevin, March 2006
link Click here to see other fixes for Kenmore.