I need to remove the housing on the Peugeot 206 indicator stalk, as was mentioned in a previous answer from Chris. How do I do this ???
Ray

Ray Sellars, March 2006

my 206 is the special eddition it has the auto lights and w/screen wiper system I had a problem with the multi function indicater arm and had to replace it. to remove it first check if you need to enter a radio code because you need to dissconnect the battery. (important air bag may deploy) after dissconnecton of the battery look behind the centre spoke of the steering wheel there is a hole with a metal clip inside. push this clip with a blunt screwdriver (treet it like a button) ie do not try to lever it the air bag will pop off but you may have to push quite hard. next undo the two torx screws under the steering housing and the cowling should fall off. unclip all the wires and at the botom of the colum there is a clip you need to loosen this or remove it ,undo the centre steering wheel bolt (torx 45 type bolt) and remove steering wheel. re fit is reverse of above hope this helps and sorry about my spelling

geoff, June 2008

Hello

You need to remove your steering wheel, and then the plastic housing that sourrounds the ignition and the back of the steering wheel (this is just two screws at the front).

Right, now you will see the console (of which the indicator is part of. This is just 1 unit. This is held to the steering column be a metal band at the rear. This unscrews a bit like a jubilee clip. Once this is done you can simpley unclip the rear of the housing (plastic clips on the column) and the whole thing slides forwards.

Hope this helps!

David, January 2007