How do you fish the two fuel lines through the gas tank through the hold in the bottom of the tank. I need to replace both lines from tank and can't see how you are suppose to run tube through the tank, line it up with hold, and pull it through...

Richard, November 2009

i replaced fuel lines ona ryobi weed hornet by
empty tank first
remove plastic lock ring on fuel line where it comes
thru tank and push line into and fish out of tank, clean
off old line and push on new line,run a length of wire
up from bottom of hole into tankand then slip new line
over wirefromtank filler hole, this will guide line back thru hole,slip on plastic lock ring,while pulling hard on fuel line,this will
seat filter and enable lock ring to be hard up against
bottom of tank and lock on rib

gordon, November 2009

You feed the fuel line up from the bottom of the tank and attach the filters above the fill neck, then pull and wiggle down through tank and attach clips.

Kmack, November 2009