3 hours ago Karen asked ... Royal 480nt cash register?    |    andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    Click here to ask your question

moto stalls when turnin or cornering?

drive in straight line ok when turn stalls
pete brown, November 2009
You have a live exposed wire hitting somewhere off the frame or engine creating a short circuit in the wiring loom. Basically when you turn the bars the loom is getting pulled in towards the frame & rubbing off it. This constant rubbing has probably worn through the protective outer covering & wires inside making them earth off the bike.
Look along the wiring loom for any chaffing or rips, if you find the exposed wire & it's not broken, then tape it up with some electrical insulating tape. Try & move the loom so it's not going to be rubbing off that particular spot again.
Hope this helps...

Steo, November 2009