Is there a thermal cut out switch on the thermostats to stop the elements from heating the TDC62 model if it overheats ? Or is it just a case of changing the thermostatsat at the rear of the machine as previously indicated. Is this a common fault with this machine ?
Hotpoint tumble dryer TDC62.

Paul Webb, March 2006

I have a TDC60. Replaced thermostats about a week ago. Tumble action working but no heat. Asked an engineer who said that the machine should be left to run it's cycle or it should be switched to the fan symbol which would run the blowers until the elements cooled down. Apparently this will stop the heat conducting through the metal parts and blowing the thermostats. Replaced thermostats then it happened again within a week. Stuck just like you! Is there an exhaust thermostat? Is there a module which should control the heat output (only heats when the drum spins one way)? I have picked all this up from other forums. Also that if it is a faulty part Hotpoint will replace it free if machine is less than five years old - but they probably charge a fortune for the work? I have a friend who is an engineer who is having a look on Friday. Will let you know if any joy. Hope this helps a little.

Ken Cowx, March 2006