Internal sounder activated when in unset mode.
Tamper led now flashing constantly and i cannot reset system . Manual says to enter code number followed by hash key but this does nothing.
How do i re set to have alarm working again?

ron D, January 2010

i got mine to reset after taking out the mains and battery fuses and waiting 30 seconds before replacing.

colin, November 2010

check the battery. Mine just did exactly what yours did and I replaced the backup 12V battery that was reading just 5V.

Everything reset to factory settings so the cod is now 1234 but a replacement battery fixed my problem.

Mark Pepper, November 2010

Death
Pressing reset does nothing
Manual states code then Hash button to reset - again does nothing
And yes this is the first and only time this has happened

ron D, January 2010

FLASHING ahh try pressing reset on the panel or refer to the manual how to reset after an alarm activation let me know how it goes

by the way has this just happend once

death, January 2010

death
checked all sensors, main panel etc, external sounder etc could not find anything wrong. went into engineers mode and tried a few things - still no success -- tamper led still keeps on flashing -- any other ideas i can try ?

ron D, January 2010

hi ron from looking at your question you have the annoying tamper 1st thing im going to say ron is check every single sensor in your house that the lid is tight or open them clean them and stretch the springs if no diffrence check the MAIN panel is tight check the keypad and you might aswell check the bell box is still lit up or it is sounding and before you tighten the main panel you might aswell check fuses or any loose wire and try ron to press reset and see if it clears it warning the alarm may tamper but remember to press reset get back if this helps or not thanks death

death, January 2010