light saying configuration error

james, January 2010

I have daf cf 85 410 of 2010 and it has configuration error and all warnings going up on display and not starts

Nicholai, May 2017

Configuration error and its not starting ,after a reverse polarity?

chikwanda, July 2016

2007 cf 410 unit starts and runs perfect but couple times a day it will just cut out showing an array of notifications on screen, body builder module, configuration, ebs, alternator, pull truck into side of road and give it 30 seconds and it will start and go perfect again until next time maybe an hour later or maybe only minutes, daf craigavon nireland have fitted 3 new looms but with no success in sorting the problem at our wits end and driver is for quitting over it,any thoughts

joe mc carron, February 2016

Top left relay is the problem swop with the bottom left and it will start 👍

Jason, October 2015

Hi scott, I've got the same fault on a 2006 cf, was running fine last night but won't start today with all sorts of warnings on the display, config error, alternator, bodybuilder module,abs, engine, I'm thinking wiring but its strange how it was fine when I parked it up last night,

kev, June 2013

hi sandy,is your vehicle an 8x4 mixer or a tipper?

scott, January 2011

configuration error is commonly displayed on initial ignition power up if a particurlar ecu chassis number/code isnt recognised by the vehicle,on its primary boot up cycle.this can be caused by several variants...welding with no chassis protection,inconsistant connect/disconnect of ecu.s when powered up,slave starting incorrectly(reverse polarity/spike).but ,most importantly back to basics...check feeds,and earths,and plug connections.no control unit will function with out either of these.if feeds,earths,and connections good,then general rule is ecu reprogram by daf.do u have any other script on display,i.e engine warning,alternator warning,abs truck?

scott, January 2011

Getting same on a 8x4 and engine cuts out sometimes cruise and hand throttle will not work. any ideas.

sandy, February 2010