Hello
I have just mended by dryer thanks to this site, now unbelievably my Washing machine has broke again. This is the fourth time it has done this. It had an E20 error then just stops at 1min and never finishes. If you start a new wash it doesnt spin or do anything except make a noise as if it is.
I have had the PCB replaced twice and the last a pump was ordered but the guy who came just reset and told be to do hot washes and only use 1 tablet (which I have done). If anyone can at least tell me what to do to reset it again or if anyone knows anymore that would be so good thanks in adavnce

Shaun, January 2010

just got a second hand machine and it is not working. it has a light on the start/pause button but nothing on the display. Any ideas?

emma, May 2012

Had the E20 error code and after reading the help messages decided to have a go myself. The result is a repaired washing machine at no cost.
I took the washing machine onto the patio and got all the water out through the front drain and then found the small plug of fluff. Once removed i decided to put machine on a drain cycle with the garden hose running water into the machine via the front drain which cleared some of the lime scale that was building inside.So thanks to all who put previous comments that have saved me time and money.

Ross, January 2010

switch on at mains (wall socket).Switch program dial to OFF.Press start pause button and extra rinse button in together and then whilst holding these 2 buttons pressed rotate the program dial to COTTON.After 3 sec lights should sequence.Now switch program dial back to OFF.switch on,switch off,switch on.this should of reset it.E20 is a draining issue and could be to do with the routing of your drain hose.do not extend drain hose as this causes said fault.over sudding causes this fault.software on pcb has been an issue.earth leakage on the dryer element cause this sometimes too.anything around 10megs to earth is a possible issue.

ck, January 2010