andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

melcom st6000 alarm?

when i moved into my property there was a melcom st6000 already installed and i havent got the code number i took the cover off and there was a pin number written inside(2 digit) can i use the pin number to set a new code
graham, January 2010
how do i fix a break in the cable on door

k j newbrook, May 2011
how do i fix a break in the cable

k j newbrook, May 2011
Hi Graham.

You will need the user pin code and engineer code to reprogram the Melcom. By default these are 1234 and 9999 respectively. If you don't know the codes you can factory reset the unit by removing the cover and shorting out the NV RAM pins to the right of the circuit board next to the keypad. Next, remove power by disconnecting the battery and the mains. After 30 seconds, reapply the power and remove the short on the NV RAM pins. The codes (and all other programming) will now be back to the factory defaults.

Regards,
David.

David Savery, February 2010
link Click here to see other fixes for Melcom ST6000.