Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

How can I fit a new pump drain to a Bosch Classixx?

I think the pump drain is bust because I can take out the impeller! So my though is to replace it - anyone know how?
BoschStuck, January 2010
Refer to http://www.howtomendit.com/answers.php?id=54163 Baz of Lincs had alreadty documented this

Removing and re-fitting the drain pump is quite easy
• switch off the power
• tilt the machine back so that you can see the pump
• remove the plastic panel at the bottom of the machine held in by 1 torque screw (requires a t20 torque screwdriver)
• then undo the torque screw holding the pump
• you can then remove the electrical connector
• then you can remove the two spring clips with your pliers

refitting is the reverse.... check for leaks.... job done.... best of luck

BoschNotStuck, February 2010
link Click here to see other fixes for Bosch Classixx.