Hi,

I have recently had to re-route a group of three alarms wires for my Accenta G3 system and the only way to do this was to cut each one and rejoin them using small junction boxes. Since doing that I am unable to set the alarm and the PIR detector no longer work. Also, the bell box no longer works. Any suggestions on how to get the system working again?

Thanks

gavin6347, January 2010

Have a good weekend Death,
Regards
Nick

Nick, January 2010

in the main panel check for fuses that have block you need 2 glass 1 amp fuses only if you have spair in the panel replace with them if you dont you need to visit your local alarm shop

Death . p.s the fuses blown should be either aux 13v/speaker or 12v and the belllbox bell/strobe

Death, January 2010