Andrew - C asked ... Stannah 400?    |    Liam asked ... Belts for old WEBB Mower?    |    Leith asked ... Bosch Classix Type WKM41 front loader washing machine?    |    Pam asked ... Do I need to open the housing to dry the motor?    |    James asked ... Remove enterprise enrolment from an Asus Chromebook C523N?    |    Click here to ask your question

How to mend V100 vertical thermostatic mixer?

My caravan shower will not run hot after the freeze .How do I find out which part is damaged .
(thermostat or valves ) Who is the manufacturer so I can get spare parts
mandy benson, January 2010
The tap is stiff to turn on and off !

Dennis clarke, April 2014
caravan vertical thermostatic shower mixer tap v100 in chrome tmv2
available on Ebay for £55 free postage!

pIKES, June 2013
I can get the plastic non return valves craigderekmcgrathatgmail.com

Craig, May 2013
Following winter lay up our V100 leaked also. We fixed it by replacing the 2 rubber washers with 2 "whale" washers, smeared them and the inside of the unit with washing up liquid and hey presto. Must say after reading some of these forums thought that we'd end up buying a new unit - but never give up.

R Moore, April 2011
forget it -you cannot obtain any spares atall.it is usually the 2 rubber washers that have perished i have tried every place but ordinary washers are too fat when in groove

jim moore, March 2011
Name is Mike,before you buy a new mixer, (as far as I know you can not get spares for these units, I have tried) I have now repaired 3 of these units, in each case the problem was caused by a blocked hot water inlet, it seems that the frost causes the limescale depositsto break up and seperate from the pipework and bloke the hot water filter. if you need to check the thermostat unit,, remove it from the mixer body, place it under a very hot water tap, you can then see if the thermostat valve opens, if it does, then run it under a cold water tap and you should see it shut,if it works, check the "o" ring seals, replace if required,smear a little fairey liquid on them, and replace the unit,the thermostat unit are quire robust, and designed to work at quite large temp.swings so the frost should not damage them, as I said the most likely cause is a bloked hot water inlet filter, hopes this helps, Mike

Mike Butcher, March 2011
buy a new one for 75 o6

alan manley, February 2011
short term remedy if you dont want to buy a new one is to swap your hot and cold inlet connections over so as you get hot water,you can then regulate your hot water temperature from your boiler

shug, January 2011
if you have a frost problem vith the v100
we can help you we keep a large stock.
you cant get new parts so we salvage parts from
damaged valves .
viv lewis caravan repairs 07778197979
www.vlcaravansales.co.uk

viv lewis caravan repairs and sales, December 2010
Found that Caravan Components are the suppliers to caravan manufacturers so theirs is the correct replacement and the exact same unit. www.caravan-components.co.uk

Darren, December 2010
They also sell these at the caravan warehouse. www.caravanwarehouse.co.uk for £69.99 with free delivery

David, June 2010
Can't source the valves locally, but they're available on ebay for 14 quid from a company called caravanfitter

Pherg, May 2010
I have the same problem, so I dismantled the mixer and discovered that the non-return valve is damaged. If you blow into the cold inlet and then the hot inlet you will see the difference. Check your manual for a a break down of components. If you don't have the manual click on this link https://www.btowstore.com/WebRoot/BT/Shops/BT2955/492F/D4B4/25AC/9BAB/2BC9/0A0A/33E8/79E0/V100_0020_Instructions.pdf. (or paste it into your browser).

Careful taking off the tails (inlets). It calls for a large allen key. I used an adjustable plumbing wrench, but wrapped the tails in a folded paper towel so as not to damage the threads.

Now I just have to source the valves in a specialist plumbing suppliers.

Pherg, May 2010
I to have had a problem with the V100 mixer valve, I have found out that this unit is made in Italy and no one in the UK stock spares. As I see it replacing the unit is the only option, cost approx £80.00.

Ray P, April 2010
i dont think you can been told i will also have to put a complete unit in even though my husband took the connectors off we could not get them anywhere badly designed really

julie holmes, April 2010
You can get a v100 mixer at Caravan components in Hull. Telephone number is 01482 308468. They have a website. www.caravancomponents.co.uk.

Glenn, March 2010
I have had frozen ones to repair and have had to replace complete unit,all for the sake of the two brass connectors splitting,emailed Arleigh but they have not had decency to reply yet,instructions say you can replace components,but no contact details!

topfitter, February 2010