home Fix label Vehicles label_important Cars category Ford

Ford Mondeo automatic gearbox problem?

Hi, I have an N reg ford mondeo 1.8lx auto. It drives ok but it seems to wait until the engine is revving quite high between gear changes. I have changed the gear lever position sensor on top of the gearbox but no improvement. At 30mph it seems to stay in 2nd gear at 2500rpm until i take my foot of the accelerator and it will then drop into 3rd. Transmission fluid is clean and at correct level. Thanks

Steve, April 2006

home Fix label Vehicles label_important Cars category Forddone

Hi Richard, my son has a similar sounding problem on his 2003 Mondeo, it seems to do this when warmed up, transmission seems to be searching for right rev range to change Where is the n/s wheel and is it easy to replace that sensor

Kevin Cliffe, March 2014

Car starts, lever stuck and wont select gear Fully serviced. 2003 Ford Mondeo Ghia X

Ann, April 2013

HiYa...
Is it possible to replace the transmission oil filter by dropping the bottom pan only?
Mondeo Duratec HE 2.0 4speed

Cheers

mark, May 2012

wont engage gear...was fine???? v reg...55000miles auto.2nd owner....,mondeo 2./lt

jimmy, March 2011

hi i have a 2.0 auto mondeo lx, the problem is the gear lever gets stuck in park , any ideas. thank

ken, london, June 2010

i have a uk s reg 2ltr auto that keeps reving its balls to move 0 to 30mph in about 10 mins and after 30 it runs fine...... does this mean i need a new gear box??

john, April 2010

many ex-Asia mondeo gearboxes,(automatic) that i have come across break gearbox clutch hubs. Anyone with an idea of what could be wrong with them or experienced the same problem and would greatly welcome any solutions.is it our cheap transmission fluids,the hot weather, rough roads or what. Am in Botswana(Africa)

Busani Ndlovu, September 2009

I have a Ford Mondeo 97 Model, is the car rugged enough to be used in the tropics and what is the MPG like ... is it cheap enough to run .. Meltdown periods?

Kelly, June 2009

transmission fluid as started coming out of the breather pipe on top of box could you please advise

david speight, June 2009

Hi i rebuild auto gearbox,s for a living and i do lots of mondeo.
Problem could be the turbine speed sensors located in the back of the gearbox which is the oil pump,if you take the n/s wheel off you,ll see it.
richard
rbtransmissions@aol.com

richard, April 2006

link Click here to see other fixes for Ford Mondeo.