Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Spares for Performance table saw?

I have just purchased a secondhand table saw FMTC10TS, which requires some spares. Blade guard, plastic insert in table top, mitre guide, at least.
There does not appear to be a Performance site, or source for this type of parts. Are Draper tools the same, and would parts be interchangeable?
Comments and suggestions appreciated thanks.
Bryan, February 2010
hi bryan,

i'm after some parts aswell, did you have any joy finding them?

cheers john

john, October 2013
You have the tools, make them yourself make the guard and inset out of a bit a of decent Birch ply
The slot in the table to take the mitre guide are usually of a standard sizes but there are different sizes depending if it’s DIY or Trade /industrial so check first ,
Regards
Mark

Mark, February 2010