hi i have just upgraded my system and put in ade accents g4, the wiring connections are not shown on the paper work for the bell box.


any help would be greatly appreciated

thanks matt

matt b, February 2010

Here is the correct answewr and not a straight lift from the instruction booklet.

Acc4 Panel+++++++++++++++++deltabellplus

St+ (not used)
St- ====================== Stb
T ====================== second down T
A ====================== top T
D ====================== 12v+
B ====================== Bell
Then place a wire link between topT and 12v- in the deltabellplus.

Doopherdaffer, August 2011

Hi Matt, the connections on the pyronix deltabell are as follows:
-12v = Hold off negative supply
+12v = Hold off Positive supply
BELL = To bell terminal on Panel
STB = To strobe terminal on Panel
ENG HOLD = Terminal to allow maintenace in Engineer mode (Would't worry too much about this)
T = Tamper Return to Panel
T = Tamper Feed (Link this terminal to the -12v terminal in bellbox)
Hope that helps (:-)
AJP

regards

ap, February 2011