Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

Can't change code on Veritas system?

Evening all

Just bought a new house and inherited a veritas system. Want to change the code so followed internet instructions (they didn't leave manual or service book) entered current code then pressed prog but when I press prog all that happens is a low tone beep sounds and it won't let me enter "60" to change the code.

Any ideas anyone?

Cheers

Lee
Lee, February 2010
VERITAS 8 Pre-1999 panel
To change factory or USER code (4321):-

enter Existing Code *,*,*,*,
enter 0,0
enter 0,1
enter New Code *,*,*,*,
press PROG
press RESET.

OR

VERITAS 8 Post 1999

Enter Existing Code
press Prog
press 60
Enter New Code
press Prog - (chime)
reset
reset

acorn, February 2010
link Click here to see other fixes for Veritas.