getting an error 30 flashing and beeping and is constantly trying to pump water.

david, March 2010

Error i 30 can also be caused by any open circuit in the control wiring for the float level switch circuit located in the bottom of the dishwasher. I had this problem and found a faulty - loose crimp link on a switch. I traced the wiring which also incorparates the cold water supply hose solenoid. I checked for continuaty of the soleniod coil and there it was . The coil was open and this was the cause of the fault. I replaced the supply hose assembly and the dishwasher works perfectly. CAUTION. obviously disconnect the power when working or testing the dishwasher. It might be a little easier for me to find as I am a qualified electrician and it was pretty basic to me although a cicuit diagram would of helped.

sparky, April 2018

Is there a way to get to the base to empty the water without pulling the entire dishwasher out?

Deb, May 2015

worked for me too,
Thanks

Frances, April 2013

ck, how can reset the antiflood switch? cheers. karl

karl, February 2013

thanks ck, spot on answer. cheers for that.

david, March 2010

you have a leak and water has gone in to the base and operated the antiflood switch which will make the drain pump run until you disconnect from the mains.tip dishwasher on its back to get the water out of the base and reset the antiflood switch.now retry.if it floods again you have a leak inside and need to find out where from

ck, March 2010