I just did this on an old fridge I've been repairing.
If you pull-back on the seal, you will see that it is held in place by tiny hex-screws. These screws also hold in the plastic molding of the interior door.
You will have to carefully remove all the little screws, pull the lining off, put the new one on, and put all the screws back in.
Note: It may be easier to remove only 2-3 screws at a time, pull out the seal, and screw the screws back in. This would make it easier that removing everything at once, have the entire door fall apart, etc.
Good luck!
This can be a lengthy project ... as the door on my Kenmoore had about 50+ screws.
Jonaric, August 2006
