I just installed a new battery in my 95'VFR750F and the alarm is constantly armed. I don't have the alarm manual. The fob is a two button (red and green) model.
Thanks
Mark
I've tried that, too. I'm in contact with the company and sent them pix. Hopefully, they can assist. I know its not complicated. I've done it many times in the past..just can't remember what I did.
Thanks for your help.
Mark, March 2010
I've tried that, too. I'm in contact with the company and sent them pix. Hopefully, they can assist. I know its not complicated. I've done it many times in the past..just can't remember what I did.
Thanks for your help.
Mark, March 2010
I've tried that, too. I'm in contact with the company and sent them pix. Hopefully, they can assist. I know its not complicated. I've done it many times in the past..just can't remember what I did.
Thanks for your help.
Mark, March 2010
try holding both buttons down at the same time for a few seconds that is how a datatool fob is realigned with the alarm unit.its worth a go but i ahve not heard of this specific alarm before.
adam bike doctor, March 2010
I've searched the internet with no luck. It's a model no longer sold but seems to be very similar to the i300 model on Scorpio/Aritronix web site. They have a manual online but no instructions for this.
I believe it is some combination with the fob - just can't remember what I've done in the past. I was looking for someone on here that knows. The alarm won't have to be removed. Thanks for responding.
Mark, March 2010
reset not rest!
bb, March 2010
On most alarms to rest them you have to let the alarm go off for the 30 secs or so until it stops and then you will need your remote to put in code. The manual expalins how. You may be lucky and its not been reset from default setting. But you may be unlucky and this has been changed. Its like a PIN code for you bank card or mobile phone. I would serach internet for instructions and try it out. Other wise you may have to remove alarm.
