The machine fills up with water but will not move.I have tried holding start button .It then just emptys

steve, May 2010

I disconected the four wires from the 'ON/OFF' switch (this was so I could get at the PCB) and forgot to mark them, now I can't seem to connect them in the right place. I'm blowing fused right left and centre. Is there a wiring diagram available or some way that I can tell what goes where? There are two orange leads and two grey leads. I know that the orange goes on top and the grey underneath, I'm starting to blow my own fuse.

DAIJON, June 2012

The start cancel button seems not to be doing anything, changing program, power on and off door open or closed. machine just does nothing, There has been a problem with the door swithch and needs a hard push to get it start, could it be the door switch faulty or pcb problem

Martin, June 2011

Check the wiring is ok to the motor connector.check the motor brushes are ok and not worn out.Faulty windings on the motor or main control pcb faulty

ck, May 2010