Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

home Fix label Security Systems label_important Home Alarm Systems category Veritas

Why does the alarm go off with the Tamper light lit?

After replacing the battery in our Veritas alarm and resetting using the engineering codes, the alarm goes off randomly, even when not set and it's always the Tamper light that is lit, not any other zone light. Why would this be?
Diddly, May 2010
home Fix label Security Systems label_important Home Alarm Systems category Veritasdone
There will be a tamper switch on the main alarm where you replaced the battery.just check that when you put the cover back on it pressed the tamper switch down

A1 Secutity, May 2010
link Click here to see other fixes for Veritas.

Fix Fault - Security Systems

home label Security Systems label_important Home Alarm Systems

Cooper Scantronic 9448 alarm?

Security Systems > Home Alarm Systems > Scantronic

Gardtech 800 Alarm?

Security Systems > Home Alarm Systems

CEF AP28 alarm issue?

Security Systems > Home Alarm Systems

Thorn tc3800 house alarm?

Security Systems > Home Alarm Systems > Thorn

Accenta G4?

Security Systems > Home Alarm Systems > Accenta

Concept 6?

Security Systems > Home Alarm Systems

Veritas Alarm panel unable to set user code?

Security Systems > Home Alarm Systems > Veritas

Accenta 6 alarm system?

Security Systems > Home Alarm Systems > Accenta

Fix Fault - Security Systems

home label Security Systems label_important Home Alarm Systems

fixfault.com

fixfault.com for free repair help, information and advice.

How can I fix my Scantronic 9752?
How can I fix my EuroSec PR5208?
How can I fix my Paragon Plus?
How can I fix my Risco Gardtec 300?
How can I fix my Citadel XR2?