Mike asked ... Bosch WTA74200GB Vented Dryer?    |    Stuart G asked ... C3 Front Wiper control problem?    |    Clare S asked ... Repair Electriq dehumidifier?    |    Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Click here to ask your question

white knight, is it the element?

Hi, I have a white knight cl847, on the high heat setting the drum spins for a few seconds stops, then spins for about a minute in the other direction seems to be heating up then stops, the reset button does not need pressed. If I wait for a minute it comes back on when the start button is pressed. On the low setting the dryer seems to run ok but with no heat. I have replaced the brush at the top of the drum and the exhaust sensor. Do you think it’s the element? Any help would be great.
Colin, June 2010
Hi again, I have now replaced the element and the sensor beside it, as well as the bits listed above. The problem is still there. Any ideas, please help.

Colin, July 2010
at the back is a large round element with 2 elements built in to it.both elements should be around 49ohms across the inner pair (1 element) and the outer pair of terminals (2nd element)

ck, June 2010
link Click here to see other fixes for White Knight.