GG asked ... Fix food processor motor?    |    T asked ... How do I turn the delay off on Electrolux DX302 dishwasher?    |    Helen asked ... How can I mend my Kenwood Gourmet FP505?    |    Roy Turner asked ... Kohlangaz Gosford HE fire?    |    Peter asked ... How can I mend a Powerwasher PRO PRO1800PWE?    |    Click here to ask your question

Veritas 8 alarm, cut through sensor (pir) wire - help?

Hi
I was recently doing some DIY and removed a skirting board. Unbeknown to me inside it was the wire that leads to the sensors for my alarm. I imediately went to B&Q and bought a junction box the type that u match the colours either side shove the wires in and they cut thru the plastic to make a contact. Switched it all back on and the 2 zones 2 and 3 (the cut ones) remain lit on the control panel and there is beeps. The sensors are not flashing red either. So I undid the junction box and exposed the metal in the wires and twisted each of them to the corresponding colours, the alarm sounded outside.. i put my code in, it went off but zone 2 and 3 remain lit. Im unable to put my alarm on now. Im wondering after the wires are connected back up if there is a hidden button on the sensor i need to press or do i need to re programme the sensors back to the control panel? please any help appreciated as i dont have the money for an engineer! thanks very much
louella baker, June 2010
I do love 'nearly right' answers.

F1 1Amp - Battery
F2 500mA - Aux 12v & Speaker
F3 1Amp - Bell & Strobe
F4 500mA - Keypad Network
F5 1.6Amp - Power Supply

acorn, June 2010
There may be a blown fuse in the main panel, do other sensors light up?
There glass 1A fuses, available from maplins etc.

Jim, June 2010
link Click here to see other fixes for Veritas 8.