1 hour ago andrew smith asked ... 2009 fiesta 1388 cc titainum?    |    Eric asked ... Strimmer fuel line?    |    Frank asked ... Working fine. No cold air?    |    c.m.brown asked ... Replace chuck on aeg power drill sb2e 700r?    |    tom dimmock asked ... How can i mend the lid on russell hobbs elec?    |    Click here to ask your question

MTD 548 blade sharpeneing?

Do I have to remove the blades to sharpen the cutters
Badja, July 2010
You should remove them, clean them right off and weigh them after sharpening. get their weights as close as possible, at least in pairs which should then be fitted opposite each other to reduce vibration. Poorly balanced blades will wear the bearings out in the cutter deck.

Jules, July 2010
link Click here to see other fixes for MTD 548.