Bob asked ... Charger fault?    |    Terry nelson asked ... How to remove the flexible shaft from a curved shaft ryobi t?    |    Matt Longmore asked ... Non-start on Flymo XLT 250?    |    John asked ... How to fix my fireplace?    |    Ian Scott asked ... Remove cover off gas boiler?    |    Click here to ask your question

my poulan chainsaw will not start after using it?

after using my poulan chainsaw and it is hot it will not restart How and what should I lfor to fix it
bikerbigtex@aol.com, June 2006
OR, you might have scored thr piston and cylinder, which is fatal.
new piston + rings, and hone the cylinder. If its one of the cheap ones save it for parts or toss it

Smith, September 2006
Have you taken the blower housing off and checked the fins and interior for debris? Blow out with low pressure air if possible or take a brush to it, or both. This can cause the overheating. Also check to see if your air filter is dirty it can cause the engine to overheat too. Take the Foam Filter and clean it with soap and warm water let dry, then pour a little oil, just enough to coat it (if when you squeeze it oil leaks out, there is too much, take a cloth and squeeze out the excess. Replace. (If the filter is falling apart replace with new.) Also check the exaust (muffler) Clean it too. Hope this helps.
TMC

Time, June 2006